| 1. |
Disconnect the battery negative cable, and
wait for at least three minutes before beginning
work. |
| 2. |
Loosen the sliding bar mounting
bolts. |
| 3. |
Remove the following parts. (Refer to BD
group)
| A. |
Door scuff trim, Quarter
trim | |
| 4. |
Remove the upper anchor
bolt. |
| 5. |
Loosen the Seat Belt Pretensioner mounting
bolt and remove the Seat Belt
Pretensioner. |
| 6. |
Disconnect the Seat Belt Pretensioner
connector.
|
| 1. |
Remove ignition key from the
vehicle. |
| 2. |
Disconnect the negative (-) cable from battery
and wait for at least three
minutes. |
| 3. |
Connect the Seat Belt Pretensioner connector
to the SRS main harness connector. |
| 4. |
Install the Seat Belt Pretensioner (BPT) with
bolt. |
| 5. |
Install the upper anchor bolts.
Tightening Torque (Seat Belt Anchor
Bolt)
: 4.0 ~ 5.5 kgf.m (39.2 ~ 53.9 Nm, 28.9
~ 39.8 lb.ft)
| |
| 6. |
Install the following parts (Refer to BD
group).
| A. |
Quarter trim, Door scuff
trim | |
| 7. |
Install the sliding bar mounting
bolts. |
| 8. |
Reconnect the negative battery
cable. |
| 9. |
After installing the Seat Belt Pretensioner
(BPT), confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
